Dyaco Treadmill Model 909 Manual Lawn

• 1216 Answers SOURCE: surely there is some problem in the belt. One of the ways to extend the life of your treadmill is to keep it clean and dust-free. Dirt and dust build-up, especially between the belt and the deck of your treadmill can cause excessive belt-deck friction.

This in turn, can damage your electronics and even your motor. You can check for excessive belt-deck friction by setting your treadmill around 4 MPH and walking on it. Press the stop button (or pull the emergency stop switch). You should have to take a few steps before the belt stops - if it stops suddenly there is probably a high friction problem.

OWNER’S MANUAL ASSEMBLY‧OPERATION‧MAINTENANCE WARRANTY‧PART ORDERING. Treadmill to the slowest speed to provide for safe dismount and low speed restart.

Vso Image Resizer 4. Excessive belt-deck friction can also cause motor to stall or sound labored so again, keep your belt and deck free from dust and dirct and look out if this is a problem Posted on Jan 26, 2011. It sounds like the speed sensor is not close enough to the magnet, or the speed sensor is bad. It is located inside the motor area, next to the pulley on the front roller.

Well depending on what treadmill you have. It can be shaped like a pencil but shorter.

Make sure it is about a centimeter away from the magnet that ison the flywheel. Once you have moved it turn on the treadmill and try it, if it doesnt work then move the belt with your foot and every time the magnet goes past the sensor you should see a light flicker on the control board if not then the sensor needs to be replaced. Sep 16, 2010 . Unplug unit remove motor shroud then start calibration procedure.