Install Ztdummy Debian

Jan 22, 2006 - What I did: Installed Asterisk just fine using aptitude. Then installed kernel sources and build a new kernel. Osho Emotional Wellness Pdf Creator. Downloaded the zaptel source using CVS. Edited the Makefile to include ztdummy. Then did a 'make all' and after that a 'make install' What did I do wrong? PS: I have a 2.6 kernel. Help is greatly. How To Install Asterisk VOIP PBX on Debian Linux. I don’t have a land line. I don’t see the point. Make install modprobe ztdummy.

Tip While Asterisk itself compiles on a variety of platforms, the Zaptel drivers are Linux-specific—they are written to interface directly with the Linux kernel. There is a project at that provides Zaptel support for Solaris. There is also a project that is working to provide Zapata drivers for BSD, located. Bonusbots Download.

First we will discuss the ztdummy driver, used on systems that require a timing interface but that do not have hardware. Then we will look at compiling and installing the drivers. (The configuration of Zaptel drivers will be discussed in the next chapter.). Tip Before compiling the Zaptel drivers on a system running a Linux 2.4 kernel, you should verify that /usr/src/ contains a symbolic link named linux-2.4 pointing to your kernel source. If the symbolic link doesn’t exist, you can create it with the following command (assuming you’ve installed the source in /usr/src/): # ln -s /usr/src/'uname -r' /usr/src/linux-2.4 Computers running Linux 2.6 kernel-based distributions do not usually require the use of the symbolic link, as these distributions will search for the kernel build directory automatically. However, if you’ve placed the build directory in a nonstandard place (i.e., somewhere other than /lib/modules/ /build/), you will require the use of the symbolic link.

While Asterisk and the other related packages run on Linux 2.4.x kernels, development is done first and foremost on 2.6.x kernels and support for 2.4.x kernels is not guarenteed in the future. Note Many older systems (and some newer ones) use an OHCI USB controller chip, which is incompatible with ztdummy. However, if you’re using a 2.6 kernel there is no need to worry about which USB controller chip your system has. The driver looks to see that the usb-uhci module is loaded and that the kernel version is at least 2.4.5. Older kernel versions are incompatible with ztdummy. On a 2.6 kernel-based distribution, ztdummy does not require the use of the USB controller.